Hi, Newbie & Help Needed :)

Discuss 3D printing software.
Post Reply
tomp87
Posts: 1
Joined: Sat Jun 08, 2019 4:24 pm

Hi, Newbie & Help Needed :)

Post by tomp87 » Sat Jun 08, 2019 4:32 pm

Good Afternoon Everyone,

I hope everyone is well and good?

My name is Tom, I first got interested in 3D printing as an Undergraduate around 4 years ago nearly, while my friend built and a few and did some work. Everytime I discussed with him, it always became confusing!!!

As a Postgraduate, I wanted to work with 3D printing but got told, I was too technical, which halted my desire and pathway emerging, this would have been Photography & 3D printing combined.

However, since then this urge to get into 3D Printing has never stopped me at all and I feel now finally is the time to get it done!!!

I'm on a budget and have been looking at the Creality Ender Pro 3, which is around my price range and have so far heard good things about it.

I'd also like to know what software would I need to download to use it?

Another final question, What GB laptop or desktop would I need to run the software?

I appreciate your time and help within regards to this, I look forward to hearing from everyone and in the meantime, take care & warmest regards.

Tom.



Creatorgirl13
Posts: 3
Joined: Tue Nov 05, 2019 10:14 pm

Re: Hi, Newbie & Help Needed :)

Post by Creatorgirl13 » Wed Nov 06, 2019 11:59 pm

cura, simplify 3d and Intamsuite are sick slicer programs for the Intamsys Funmat HT, here are the differences in them to think really hard about where you stand to get started lol - tried each one but I decided simplify3d was the best!

https://visionminer.com/pages/software



Post Reply