Hello everyone. IV got an issue I'm hoping someone can shed some light on.
I have a 3d printer plugged into a 4 gang extension along with my laptop. The two are connected to each other via USB and I run repetier host to communicate.
My airbrush compressor is sat about 5 foot from my laptop and about 7 from the printer.
Whenever my compressor kicks in my printer disconnects from repetier host
I can't for the life of my understand why this is and therefore have no idea how to combat it.
Any ideas would be a great help.
Thanks in advance for any replies,
Everything else here.
1 post • Page 1 of 1