Newbie problems
Moderator: CrazyIvan
Newbie problems
Just built a Anet A8 Omni printer did a home all and levelled the bed and did a test temperature piece which came out ok til it fell over, have had success with a test circle now every time I reset the bed and do a print the printer raises the head half way up then comes down and starts printing about 3 inches above the bed is this a printer problem or the g-code
- iDig3Dprinting
- Posts: 192
- Joined: Thu Jan 29, 2015 5:04 pm
- Location: Stroud, UK
- Has thanked: 1 time
- Been thanked: 4 times
- Contact:
Re: Newbie problems
This sounds like a problem with the settings.
Firstly, when you start the print is the print at the height of the 3" above the bed? It is probably confused as to where the home is for the z axis.
either that or check that you have not entered a very unusual z-offset in your slicer.
Firstly, when you start the print is the print at the height of the 3" above the bed? It is probably confused as to where the home is for the z axis.
either that or check that you have not entered a very unusual z-offset in your slicer.
iDig3DPrinting -
Your source for 3D printers, 3D printing accessories and filament.
Your source for 3D printers, 3D printing accessories and filament.
Re: Newbie problems
Home all zeroes head to 2mm off bed,I have downloaded several G-code designs lately have been downloading some stl and have used Cura ver 15 to convert to G-code but there is nothing in Cura basic to change Z
- iDig3Dprinting
- Posts: 192
- Joined: Thu Jan 29, 2015 5:04 pm
- Location: Stroud, UK
- Has thanked: 1 time
- Been thanked: 4 times
- Contact:
Re: Newbie problems
Hi sorry for the late reply.
PLease take a look at : https://ultimaker.com/en/community/1709 ... et-in-cura for some guidance on altering z height in the g-code. it could be that some how you have a corrupted calibration.h file. you could try reloading this on to the board. We don't run Anet A8 so we cannot be sure how much versatility you have when it comes to your printers firmware.
PLease take a look at : https://ultimaker.com/en/community/1709 ... et-in-cura for some guidance on altering z height in the g-code. it could be that some how you have a corrupted calibration.h file. you could try reloading this on to the board. We don't run Anet A8 so we cannot be sure how much versatility you have when it comes to your printers firmware.
iDig3DPrinting -
Your source for 3D printers, 3D printing accessories and filament.
Your source for 3D printers, 3D printing accessories and filament.
-
- Posts: 25
- Joined: Thu Mar 15, 2018 10:31 am
- Been thanked: 1 time
Re: Newbie problems
This is probably a problem with the settings of your 3D printer. Look into the user manual of your 3D printer and it would offer you instructions on how to level the 3D printer bed effectively.
https://www.3dprintersonlinestore.com/d ... 3d-printer
https://www.3dprintersonlinestore.com/d ... 3d-printer