Slow heating bed

General discussion on 3D hardware from beginner to expert.
Post Reply
Posts: 3
Joined: Wed Jan 31, 2018 10:32 pm

Slow heating bed

Post by fodis_uk » Sat Feb 10, 2018 4:47 pm

Ive noticed my bed is slow to heat past 80 degress which understandable for it to take longer at higher temps but I've noticed recently even heating to 55 for pla is slower than normal, went to print some abs today which I don't print very often and it would not exceed 96 degrees even heating for nearly half an hour, tronoxy printer aluminium hot bed ,

Posts: 24
Joined: Thu Mar 15, 2018 10:31 am
Been thanked: 1 time

Re: Slow heating bed

Post by steveprinters29 » Fri Apr 06, 2018 11:58 am

There seems to be a trouble with the temperature settings of your 3D printer. And to resolve this, you need to look into the user manual of the equipment. The document would contain the required temperature settings so that you help your 3D printer bed get heated to the required temperature.

Posts: 29
Joined: Tue Dec 19, 2017 2:51 am
Been thanked: 1 time

Re: Slow heating bed

Post by Kmxsoft » Sun Apr 15, 2018 9:45 am

If yours is a Creality CR10 then bed heating is inadequate - this is due to the heating depending on a 12v power supply which unfortunately cannot provide enough power. Upsizing the power supply won't fix that.

Changing to a Keenovo can solve this: ... /808779673

You also need a solid state relay to switch the bed on/off: ... Sw-W5UweF8

WARNING: The Keenovo is MAINS POWERED so could be lethal if incorrectly installed. This is very definitely an upgrade which should be installed by a competent electrician.

I installed a Keenovo and it takes seconds to reach 110 degrees - necessary for printing with ABS.

Creality CR-10S owner posting as a private individual.

Post Reply