CR-10s Mesh Leveling Question
Posted: Fri Sep 07, 2018 5:20 pm
Hi,
I’m new here but was hopning someone could answer my question as i can’t seem to find a straight answer from googling!
I am 99.9% certain that the x-gantry on my CR-10s is bowed upwards ever so slightly. This causes the nozzle to always be too far away in the centre (or too low at the sides if I raise the bed).
I don’t really want to have to replace the gantry, so my question is:
If I update the firmware to use mesh levelling, will it be able to compensate for the gap caused by the bowed gantry?
I want to be sure it will help my issue before I upgrade, since the upgrading process looks to be quite complicated!
(And I have already replaced the glass with 6mm thick mirror that is definitely flat!)
Any help in this matter would be greatly appreciated, Thanks.
I’m new here but was hopning someone could answer my question as i can’t seem to find a straight answer from googling!
I am 99.9% certain that the x-gantry on my CR-10s is bowed upwards ever so slightly. This causes the nozzle to always be too far away in the centre (or too low at the sides if I raise the bed).
I don’t really want to have to replace the gantry, so my question is:
If I update the firmware to use mesh levelling, will it be able to compensate for the gap caused by the bowed gantry?
I want to be sure it will help my issue before I upgrade, since the upgrading process looks to be quite complicated!
(And I have already replaced the glass with 6mm thick mirror that is definitely flat!)
Any help in this matter would be greatly appreciated, Thanks.