Ok so having just built another printer and turned it on loaded a model from the sd card and sent to print
Nothing, then a thin line of filament then clicking then nothing,
then filamnet comming out in Blob, then the filament on the bed is dragged off by the extruder then nothing.
other people seem to build then sent to print an hey presto they have a 3d model me
jeeze what am i doing wrong 1.75 extruder heated to 205 heated bed to 60c tape on the bed filament loading ok just nothig that resembles a 3d model or anything any advice would be great
General discussion on 3D hardware from beginner to expert.
1 post • Page 1 of 1