Good uses for Duplication and Mirror mode?

General discussion on 3D hardware from beginner to expert.
Post Reply
KrappsLastBake
Posts: 1
Joined: Wed Oct 17, 2018 2:50 pm

Good uses for Duplication and Mirror mode?

Post by KrappsLastBake » Thu Oct 18, 2018 2:33 pm

I have bought the BCN3D Sigma R19 recently (https://robosavvy.com/store/bcn3d-sigma-r19.html) and I have been trying to find some novel and unique models to try out the Sigma's Duplication and Mirror modes. Has anyone out there had any experience with this and used it to their benefit? I am looking for ideas that aren't just "print the same model twice".



Post Reply