www.3dprintersforum.co.uk | 3D Printer Forum UK

so i bought a anycubic mega i3-S

built it, levelled it properly "i think?"

the problem is that im having "stringy" prints and the prints are lifting.

i have tried the cura settings given in the instructions aswell as 2 other peoples recommended cura settings with the same issue

i would attach photos here but i dont see how to

It could be that if you are printing on glass that the glass is not clean I don't know if it works but I have hear hair spray on the bed can help it stick also is the bed heated and if it is, is it at the right temperature

I am having what I believe to be a similar issue.
My printer was working but now it is printing all clumpy and stringy.
I have leveled the bed and adjusted the sensor again. It slightly improved it but still bad. Need help! I wanted to print some safety masks for the NHS

What filament are you using?

You need to upload your photo to the internet. Google free picture hosting.





Please do not use PhotoBucket.... (My personal opinion) But they killed a load of forums previously
by holding your pictures to ransom. They suddenly wanted to charge money if you wanted to
share your pictures which deleted the pictures from many forums.