www.3dprintersforum.co.uk | 3D Printer Forum UK

I have a problem with the bottom 3mm of prints that I slice with creality slicer and print with ender 3 pro printer the first 3mm is really rough then after that all seems fine . I am printing at 200 nozzle & 50 bed with PLA. I have printed a test dog that came on the SD card with the printer and that prints lovely but that prints with a raft and I am not using a raft on the faulty print. I have photo's but don't know how to upload them in this post

You can try uploading photos to any site (like imgur.com for example) and insert images into your message then.

Sounds like your nozzle is to close to the bed. It evens out after smudging the pla around for a few layers. Try to relevel your bed with a bit of paper. It shoukd slide with very little tension