I am new to the forum as I have just acquired my first 3D Printer.
I've managed to get a manual for the printer and software but the problem I have is on the main board.
It is missing one of the stepper driver control modules.
I've attached some images of the printer and the main board. If someone knows which stepdrv modules this printer needs I would be most grateful. I think I read somewhere about the modules used for this printer are reversed to standard ones. Again I'm a total beginner so any advice would be really appreciated.
Sly Si 84.
General discussion on 3D hardware from beginner to expert.
1 post • Page 1 of 1