HELP!

General discussion on 3D hardware from beginner to expert.
Post Reply
Tom_nerd
Posts: 1
Joined: Sun Dec 27, 2020 6:01 pm

HELP!

Post by Tom_nerd »

I just got a 3d printer for Christmas and set it up as the instructions asked but when I went to remove the print it was incredibly hard. I eventually managed it after a few minutes of shouting. but when I did the first layer had remained stuck to the print bed. I have 2 questions:

1. what did I do wrong for this to happen

2. what can I do to get the first layer off the print bed.

Link to picture of print bed:


thanks in advance,
Tom :D



Post Reply