help again

General discussion on 3D hardware from beginner to expert.
Post Reply
PAUL1962
Posts: 23
Joined: Mon Aug 06, 2018 9:26 pm

help again

Post by PAUL1962 » Fri Sep 28, 2018 12:13 pm

Not getting much joy, but I will try again, my lattest problem is no matter what is on the SD card, the printer just prints out a long ish blob then sort of cuts a grove in to it and get to 24% then comes unstuck and comes off the board

what amI doing wrong ? it doesnt matter what is on the card the printer doesnt want to print out anything

please help

Paul



Post Reply