Anyone with experience of LCD printers

General discussion on 3D hardware from beginner to expert.
Post Reply
pete
Posts: 1
Joined: Fri Aug 30, 2019 8:14 am

Anyone with experience of LCD printers

Post by pete » Fri Aug 30, 2019 1:00 pm

Hi,

I have a reprap pro and an old makibox, both ABS FDA.

I want to do flexible models, and based on the success of a form 3 that we have at work I'd like to try some light curing solutions. I just noticed that Creality do an LD-001 for a few hundred pounds, and also Anycubic photon is even less.

Does anyone have any experience of these printers. I'd like to know how much faffing and setup is required, if there is a tough resin that is comparable to PLA/ABS and if they do flexible well? Basically are these good printers?

Thanks
Pete



Post Reply