new printer issues!

General discussion on 3D hardware from beginner to expert.
Post Reply
Casty
Posts: 1
Joined: Thu Sep 19, 2019 4:51 pm

new printer issues!

Post by Casty » Sat Sep 28, 2019 3:04 pm

so i bought a anycubic mega i3-S

built it, levelled it properly "i think?"

the problem is that im having "stringy" prints and the prints are lifting.

i have tried the cura settings given in the instructions aswell as 2 other peoples recommended cura settings with the same issue

i would attach photos here but i dont see how to



Jack
Posts: 8
Joined: Sun Jan 12, 2020 5:17 pm

Re: new printer issues!

Post by Jack » Mon Jan 13, 2020 9:30 pm

It could be that if you are printing on glass that the glass is not clean I don't know if it works but I have hear hair spray on the bed can help it stick also is the bed heated and if it is, is it at the right temperature



Post Reply