PrintBite fitting

General discussion on 3D hardware from beginner to expert.
Post Reply
Septic
Posts: 2
Joined: Sun Nov 24, 2019 3:23 pm

PrintBite fitting

Post by Septic » Mon Nov 25, 2019 10:24 pm

I currently have a Wanhao i3 Plus 2 which I bought New recently off eBay for a very respectable £250.

After reading many good reviews and watching many positive online videos, I decided to buy a sheet of PrintBite.
But Before fixing permanently, I had another quick look online for info on sticking it down properly and curing the adhesive so it stays put.

The only i3 plus related post I found suggested that it was still necessary to stick it to a glass sheet ?, although the sturdy magnetic bed upper supplied with the printer is intended as a build surface Anyway and is very stable due to its strong magnetic bond to the heated bed.

Has anyone experienced any problems with PrintBite stuck directly to a dedicated print bed? 🤔



Post Reply