CR-10S Pro leveling failure

General discussion on 3D hardware from beginner to expert.
Post Reply
Another_Dave
Posts: 2
Joined: Tue Nov 26, 2019 10:03 pm

CR-10S Pro leveling failure

Post by Another_Dave » Tue Nov 26, 2019 10:22 pm

When going through the leveling steps with CR-10s pro, as the nozzle lowers down the inductor led goes red then it moves back up up, repeats this, then on the 3rd attempt the inductor goes red and it decides to ignore and continue to level down hitting the plate.

At the end of sample video I switch off the printer to prevent further damage.

https://youtu.be/A38SHmJOsKw

Any ideas what caused this and how to fix?



Another_Dave
Posts: 2
Joined: Tue Nov 26, 2019 10:03 pm

Re: CR-10S Pro leveling failure

Post by Another_Dave » Wed Nov 27, 2019 3:09 am

Fixed it now.

I had to grit my teeth and allow it to buckle into the bed then manually hit the z axis plus until it unberried itself.

Not a very good design.



Post Reply