new to it all

General discussion on 3D hardware from beginner to expert.
Post Reply
Coreservers
Posts: 1
Joined: Wed Dec 04, 2019 1:55 pm

new to it all

Post by Coreservers » Wed Dec 04, 2019 2:03 pm

Hi there. just had the fun, and actually it was fun, building my new ender 5. wasnt too hard but was helped / hampered by my 8 year old. lol..

Currently running the dog model of the sd card. tried the cat and it didnt stick to the magnetic plate causing a bit of a mess. but the dog is 61 percent done and looking good quality. was looknig on line and some folks recommend buying tl smoothers for this machine. they dont look too expensive,

Overall it seems a nice sturdy and reasonable easy to use 1st 3d printer. whats the forum opinion?



Post Reply