Problem getting Anet LCD2004 working on a Geeetech controller

General discussion on 3D hardware from beginner to expert.
Post Reply
dthomson39
Posts: 1
Joined: Sat May 16, 2020 7:06 am

Problem getting Anet LCD2004 working on a Geeetech controller

Post by dthomson39 »

Newbie to 3D printing but I have a 5 button LCD 2004 display which works fine on an Anet board (which failed) and I replaced it with a Geeetech 2560 which works fine apart from the LCD display which doesn't even light up when plugged in. Has anyone had this experience and knows a fix? I have tried to find the pinout but don't seem able to find it for both units. Any help welcomed.



Post Reply