Tiny Gears – Testing Proof of Concept
Posted: Mon Sep 18, 2023 9:19 am
Hi all, thought I would share my experiments in anticipation of a larger project with you.
I drew up some gears using the gears workbench add-on in FreeCAD. They’re 12mm outside diameter, 2mm thick, and with a pivot hole 3mm diameter. The plate they’re fitted to has pivot pins printed on it (click through to run video):
I think the teeth could go smaller, especially if I didn’t use the “involute” profile in the gear generator. The main problem I had was the pivot pins tended to snap off the base plate (too small a contact area to get good adhesion).
I drew up some gears using the gears workbench add-on in FreeCAD. They’re 12mm outside diameter, 2mm thick, and with a pivot hole 3mm diameter. The plate they’re fitted to has pivot pins printed on it (click through to run video):
I think the teeth could go smaller, especially if I didn’t use the “involute” profile in the gear generator. The main problem I had was the pivot pins tended to snap off the base plate (too small a contact area to get good adhesion).