Weird curling of only the skirt or brim

General discussion on 3D hardware from beginner to expert.
Post Reply
DanielG
Posts: 1
Joined: Fri Oct 01, 2021 9:09 pm

Weird curling of only the skirt or brim

Post by DanielG »

Trying to print in PLA but I have a weird problem. I hadn’t printed anything in probably 6 months decided to get back into it and tried to print a small object, I print with a brim on small prints so it doesn’t lift. However any brim or skirts curl up really bad into like bands. But the actual print doesn’t curl at all and prints fine. The only difference other than time is an update to a newer cura.

The settings are the same
The bed is level
And I’ve always used glue stick just fine for plate adhesion.

Any ideas?



Post Reply